CITROEN C8 2005 - During the Operation; Safety Requirements: Hydractive 3 Hydraulic Suspension

SAFETY REQUIREMENTS: HYDRACTIVE 3 HYDRAULIC SUSPENSION
300
HYDRAULICS
C5
All operations on the Hydractive 3 hydraulic circuit must be performed in conformity with the following requirements and regulations:
Authorities competent in matters of health:
- Accident prevention.
- Environmental protection.
WARNING: Operations should be carried out by specialised personnel who have had training in the safety requirements and precautions to
be taken.
Safety requirements.
ESSENTIAL: In view of the special features of the hydraulic suspension system, observe the requirements below, before undertaking any
repair.
IMPERATIVE: Depending on the operation to be carried out, respect the requirements for supporting and securing the vehicle.
Wheels hanging Wheels not hanging
Vehicle on the ground Vehicle 4-column lift
During the operation.
Wait for the pressure in the hydraulic circuit to fall fully before disconnecting the unions on the following components (risk of sudden sinking of the
vehicle):
- Built-in Hydro-electronic Interface (BHI).
- Front suspension cylinder.
- Rear suspension cylinder.
- Front stiffener regulator .
- Rear stiffener regulator.
2-column lift or secure the vehicle
on 4 axle stands
Depressurisation of the circuit
(see corresponding operation)
Checking and adjusting of
heights (switch on ignition)
Other operations (depressurisation of
the hydraulic circuit)
Angl.T3-page300-321-2005 4/02/05 15:33 Page 300