CITROEN C8 2005 - Additional Operations; Adjusting the Camshaft Position Sensor; Sensor Re-Used; New Sensor

166
ENGINE
Additional operations.
Refit:
- The inlet valve cover (7).
- The 16 fixing screws and the 2 screws at refs. 1 and 2 for the camshaft bearing caps cover.
- The camshaft position sensor (without tightening its fixing screw).
Tighten the 19 screws : 9 ± 0,1 m.daN (in the sequence indicated).
Adjusting the camshaft position sensor.
Peg the engine flywheel, using tool [2].
Sensor re-used:
- Position a drill Ø 8,5 at "e" (between the inlet valve cover (7) and the camshaft position sensor (9)).
- Tighten the screw (8) : 2 ± 0,2 m.daN.
- Remove the tool [2].
New sensor:
- Place the camshaft position sensor (9) in contact with the target (camshaft pinion).
- Tighten the screw (8) : 2 ± 0,2 m.daN.
- Remove the tool [2].
Complete the refitting.
CHECKING THE VALVE TIMING
Engines: RHL - RHR
B1EP1FPC
C5
B1BP2XLD
Angl.T3-page032-190-2005 4/02/05 15:15 Page 166