248
CLUTCH
GEARBOX
TRANSMISSION
4 HP 20 “SHIFT LOCK” GEARBOX CONTROL SPECIFICATIONS AND PRECAUTIONS
Engines: XFW - 4HW
SHIFT LOCK.
The “shift lock” is a system which locks the gear selection lever in the park position «P».
Unlocking the “shift lock” (normal operation).
Switch on the ignition.
Apply the brake pedal and keep it pressed.
Using the selection lever, disengage from position «P».
Unlocking the “shift lock” (with a fault).
If it should be impossible to unlock the shift lock with the normal operation method, the causes of the fault
may arise from the following components:
- “Shift lock”.
- Gear lever position switch.
- Automatic gearbox ECU.
- Electrical harnesses.
- Battery voltage.
Remove:
- Unlock the “shift lock” (4) using a screwdriver, placed in the aperture of the gear selection control grid.
- Move the selection lever to disengage from position «P».
B2CP3N8C
C8
Angl.T3-page207-255-2005. 4/02/05 15:19 Page 248
To Next Page
Loading...
