303
HYDRAULICS
SPECIFICATION - IDENTIFICATION: SUSPENSION SPHERES
Special features
Identification.
The «slimline» spheres are grey in colour, with multilayer membranes.
IMPERATIVE: It is impossible to recharge or overhaul the «slimline» spheres with nitrogen.
The number marked on the suspension sphere is the component reference and not the Replacement Parts No.
The two-figure number marked on the suspension sphere indicates the initial pressure rating value.
Example:
The pressure rating of this type of suspension sphere is given merely as a guide.
When checking, the value read could be higher than the nominal value.
Suspension cylinders on the same axle should be equipped with the same type of suspension spheres.
IMPERATIVE: Tightening torques for suspension spheres : 2,7 ± 0,5 m.daN.
Suspension sphere
marking
HF 066 00 13h59 57
Day in year of
manufacture
Year of
manufacture
Time of
manufacture
Pressure rating
(bars)
C5
Angl.T3-page300-321-2005 4/02/05 15:33 Page 303
To Next Page
Loading...
