CITROEN C8 2005 - Checking and Toppping up the LDS Fluid Level

316
HYDRAULICS
B4BP01MC
DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
Checking and toppping up the LDS fluid level.
Start the engine.
Place the suspension height control in the "LOW" position.
Wait until the vehicle height is in the position required.
Stop the engine.
Connect the tool [1] or [2] to the vehicle diagnostic socket.
Switch on the ignition.
Successively select the following menus:
- Suspension.
- De-pressurising.
Follow the instructions given on the screen:
- Switch off the ignition, once there is de-pressurisation.
- Wait 1 minute.
Disconnect the battery
NOTE: Non-compliance with this procedure re-pressurises the suspension circuit.
Remove the engine cover.
Open the cap (3).
If the LDS fluid level is below the minmum mark "b": Add LDS fluid up to the level.
C5
Angl.T3-page300-321-2005 4/02/05 15:33 Page 316