156
ENGINE
CHECKING THE VALVE TIMING
Engine: 9HZ
NOTE: The index «e» of the dynamic tensioner roller should be centred in the interval «f».
Check the correct positioning of the index «e».
If it is not correct, repeat the operation to tension the timing belt (see corresponding operation).
Remove tools [2] and [3].
Refitting.
Refit tool using tool [1] at «b».
Remove the screw (10).
Refit the upper timing cover (12), lower timing cover (11), the accessories drive pulley (9),
the screw (10).
Tightening method for the screw (10):
- Pre-tightening : 3 ± 0,3 m.daN.
- Angular tightening : 180° ± 5°.
Remove the tool [1].
C5
B1EP1E5C
Angl.T3-page032-190-2005 4/02/05 15:15 Page 156
To Next Page
Loading...
