185
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: RHM - RHT - RHW - 4HW
B1EK1T1D
Tensioning the timing belt.
Refit the pegs [2] and [3].
Slacken the screws (8).
Tighten the screws (8) by hand.
Slacken the screws (8) by a 1/6 turn.
Slacken screw (11).
Place tool [1] on the belt at (A).
Turn the roller (anti-clockwise),using tool [7] to obtain a tension of: 51 ± 2 SEEM units.
Tighten screw (11) to 2,3 ± 0,2 m.daN (without modifying the position of the roller).
Tighten the screws (8) to 2 ± 0,2 m.daN.
Remove tool [1] to release the internal forces.
Refit the tool [1].
The tension value should be between 48 and 55 SEEM units.
IMPERATIVE: Value noted outside the tolerance: detension the belt and recommence
the operation.
Remove tools [1], [2] and [3].
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 185
To Next Page
Loading...
