187
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: RHM - RHT - RHW - 4HW
B1EK0TVC
Refit:
- The tool [5].
- The auxiliary drive pulley.
Clean the threads of the pulley screw going into the crankshaft (tap M16x150).
Brush the screw threads.
Tightening torque for the screw:
- Tighten to : 7 ± 0,7 m.daN (+ LOCTITE FRENETANCH).
- Angular tighten : 60° ± 6° (Tool FACOM D360).
Check the tightening: 26 ± 2,6 m.daN.
Refit the auxiliary drive belt (see corresponding operation).
Remove tool [5].
Refit the closing plate, tighten to 0,7 m.daN.
Tighten the wheel bolts to 10 m.daN.
Complete the refitting in reverse order to removal.
Initialise the various ECUS.
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 187
To Next Page
Loading...
