Clear-Com Tempest2400 - Other Items You May Need

Clear-Com®
Tempest®2400 2-Channel Wireless Intercom System 11
Other Items You May Need
HEADSETS
A Headset is required for each user (XLR-4F connectors).
Headsets may use Electret or Dynamic microphones. Most major brand headsets
that have the correct XLR-4F connector should be compable, requiring nothing
more than a simple Mic Gain adjustment.
DC Power Input Cable
If you plan to power the Tempest BaseStaon via DC power (Baery) instead of AC power, you will need to provide a
DC Power input Cable.
RF Cable to Remote Antennas
If you plan to remotely locate your antennas to improve antenna posioning and maximize range, you must provide
high quality 50 Ohm RF cables with RP-TNC connectors.
CAT-5 Cable for Remote Transceiver
If you plan to locate the Remote Transceiver more than 15 feet from the Tempest BaseStaon, you will need to
provide a longer CAT-5 cable. The maximum CAT-5 cable length recommended is 1,500 feet.
Accu-Sync DB-9 Cable(s)
If you use mulple BaseStaons, to use Accu-Sync BaseStaon synchronizaon, you will need to provide one Accu-
Sync DB-9 cable per addional BaseStaon.
Connecons to the Hardwired Intercom
XLR-3M/F for 2-Wire
If you plan to connect the Tempest BaseStaon to external 2-Wire party-line intercom systems, you will need to
provide the appropriate 3-PIN XLR cabling.
RJ-45 Connector Cable for 4-Wire
If you plan to connect the Tempest BaseStaon to external Clear-Com 4-Wire intercom systems, you will need to
provide the appropriate cabling.
RJ-45 to RJ-12 Adapter
If you plan to connect to an RTS 4W system you will need adapters.
Auxiliary IN/OUT ¼” Tip/Ring/Sleeve Cable
If you plan to connect the Tempest BaseStaon to external audio devices via the Auxiliary IN and/or the Auxiliary OUT
connectors, you will need to provide the appropriate balanced ¼” TRS cabling.
Stage Announce XLR-3F Cable
If you plan to connect the Tempest BaseStaon to an external audio device via the Stage Announce connector, you will
need to provide the appropriate XLR-3F cabling.
Relay Access DB-15 Breakout Cable
If you plan to ulize any of the six available relays on the back of the Tempest BaseStaon, you will need to provide an
appropriate DB-15 breakout cable to access the Stage Announce Relay and Individual Relays.
LAN Connecon RJ-45 / CAT-5 Cable
If you plan to connect the Tempest BaseStaon to a computer or local area network, you will need to provide the
appropriate RJ-45 CAT-5 cabling.