Clear-Com Tempest2400 - Shared Channel Audio and Roaming Issues

Clear-Com®
Tempest®2400 2-Channel Wireless Intercom System 69
No audio passing when not using an external hardwired intercom system and Tempest BaseStaons are
sharing intercom channels.
• Conrm that no wired intercoms are connected to the system.
• Conrm a 3-pin XLR cable connecon for each channel to be shared, between each of the BaseStaons.
• Set the BaseStaon 2-Wire Intercom Type Select Switch to the Clear-Com posion.
• Select 2-Wire for the relevant channels. Set only
one of the Tempest BaseStaons to Master Mode.
No audio passing when using an external hardwired intercom system and Tempest BaseStaons are
sharing intercom channels.
• Conrm a 3-pin XLR cable connecon for each channel to be shared, between each of the BaseStaons.
• Set the BaseStaon 2-Wire Intercom Type Select Switch to the appropriate posion.
• Select 2-Wire for the relevant channels.
• For each channel to be shared, connect the wired intercom to one of the BaseStaons.
iSelect roaming not funconing
• Conrm that the BeltStaon has been Paired with all required BaseStaons.
• Select the desired BaseStaon from the BeltStaon menu; press MENU, select “Select Base,” select the desired
BaseStaon.
• If the BeltStaon name does not appear on the Base’s LCD, conrm that there is an available slot on the desired
BaseStaon. If no slot is open, power o one of the connected BeltStaons, wait for 15 seconds, and try again.
Audio can only be passed from one BaseStaon to another in the “Clear-Com mode”
unless actually connected to to another type of wired intercom system. Connecng
any wired intercom to any BaseStaon will automacally disable Master Mode and
disconnect all shared channels that do not have a wired intercom connected.
When connecng any shared BaseStaons to any wired intercom system, only
channels connected to the wired system can be shared.