Why COBHAM Transceiver USB (Host) interface does not work?
If the USB (Host) interface on your COBHAM Transceiver EXPLORER 710 is not working, the interface might be disabled. Enable the interface by selecting the USB interface icon in the display, or by accessing the web interface and selecting Control panel > USB > Enable.
What does 'External control' mean on COBHAM Transceiver display?
If your COBHAM Transceiver EXPLORER 710 displays 'External control,' it is currently being controlled by an external application such as LaunchPad or an AT command interface. To use the built-in web interface or the display, stop the external application and restart the EXPLORER 710. Then, access the web interface through your browser.
What to do if there is no light in the power indicator of COBHAM Transceiver?
If there is no light in the power indicator or display when your COBHAM Transceiver EXPLORER 710 is switched on, the device may be in Stealth Mode. To toggle Stealth Mode on or off, press the question mark and asterisk keys simultaneously on the display keypad.
Device emits RF energy; maintain a minimum safety distance of 1m from the antenna front.
Use only approved batteries from Cobham SATCOM to avoid explosion or fire hazards.
Provides English translation of battery hazards and safety recommendations.
Maintain a minimum separation distance of 1 meter from the antenna front to a person.
Overview of the EXPLORER 710's capabilities and features for voice and data communication.
Details on the EXPLORER 710's features, including connectivity and hardware specifications.
Identification of key components and physical parts of the EXPLORER 710 terminal.
Instructions for initial inspection and unpacking of the EXPLORER 710 system.
Details on connecting various cables to the EXPLORER 710's connector panel and ports.
Steps for powering on and off the EXPLORER 710 terminal and entering the SIM PIN.
Guidance on connecting to BGAN or cellular networks and pointing the antenna.
Procedure for establishing a wireless connection to the EXPLORER 710.
Instructions for connecting to the EXPLORER 710 via a wired Ethernet connection.
Steps for connecting smartphones or IP handsets for calls via LAN or WLAN.
Accessing and navigating the terminal's built-in web interface.
Procedures for updating the terminal's software via web interface or USB.
Steps to perform a recovery software update if the terminal becomes inoperative.
A guide to identifying and resolving common problems with the EXPLORER 710.
To Next Page
General