Chapter 3: Operating the system
98-129217-D Using a phone or fax machine 27
Selecting the default outgoing call type
To select the default call type for outgoing calls, do as follows:
• Phone/Fax. Select the call type in the web interface under SETTINGS > Phone/Fax. For
further information, see Configuring the Phone/Fax interface on page 80.
• IP handset. Select the call type for each handset in the web interface under SETTINGS
> IP Handset > Call settings. For further information, see Setting the call types for IP
handsets on page 89.
Overriding the default outgoing call type
To override the default setting for a specific outgoing call, do as follows:
•To use Standard Voice for the call,
dial 1* before the number.
•To use 3.1 kHz Audio for the call,
dial 2* before the number.
Example:To make a call to Cobham SATCOM in Denmark (+45 39558800), forcing the
connection to use Standard Voice, dial 1* 0045 39558800 followed by # if calling
from an analogue phone, or off-hook key if calling from an IP handset.
Phone numbers for incoming calls
The mobile numbers for your system are listed in your airtime subscription. For example, you
may have
• 1 number for Standard Voice
• 1 number for 3.1 kHz Audio
If you have subscribed to the optional Multi-voice feature you may also have Additional
numbers, which can be assigned to individual handsets. For further information, see Additional
numbers for Multi-voice on page 38.
If the mobile numbers are listed in the web interface, you can look them up as follows:
Connect a computer, access the web interface and select PHONE BOOK > Mobile numbers.
For further information, see Viewing and editing the mobile numbers on page 57.
For information on how to make a call to the terminal, see Making a call to the terminal on
page 29.
This will not change the default call type, only the type used for the ongoing call.
The call type you are using must be selected in the web interface (refer to the next
section).
To Next Page
Loading...
