InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
ExtValue1LoLim .. 32000 [X]
This setpoint adjusts the high limit of the value of ExtValue 1 if the value is
lowered/raised by the binary inputs ExtValue1 up and ExtValue1 down. The
ExtValue 1 is never raised over this limit.
NOTE:
This limit is not taken into account if the value ExtValue 1 is written remotely
from a terminal using the appropriate command ExtValue #n.
12.2.11.22 Setpoint: ExtValue2HiLim
ExtValue2LoLim .. 32000 [X]
This setpoint adjusts the high limit of the value of ExtValue 2 if the value is
lowered/raised by the binary inputs ExtValue2 up and ExtValue2 down. The
ExtValue 2 is never raised over this limit.
NOTE:
This limit is not taken into account if the value ExtValue 2 is written remotely
from a terminal using the appropriate command ExtValue #n.
12.2.11.23 Setpoint: ExtValue3HiLim
ExtValue3LoLim .. 32000 [X]
This setpoint adjusts the high limit of the value of ExtValue 3 if the value is
lowered/raised by the binary inputs ExtValue3 up and ExtValue3 down. The
ExtValue 3 is never raised over this limit.
NOTE:
This limit is not taken into account if the value ExtValue 3 is written remotely
from a terminal using the appropriate command ExtValue #n.
To Next Page
Loading...
