InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
This setpoint adjusts the low limit of the value of ExtValue 2 if the value is
lowered/raised by the binary inputs ExtValue2 up and ExtValue2 down. The
ExtValue 2 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 2 is written remotely
from a terminal using the appropriate command ExtValue #n.
12.2.11.19 Setpoint: ExtValue3LoLim
-32000 .. ExtValue3HiLim [X]
This setpoint adjusts the low limit of the value of ExtValue 3 if the value is
lowered/raised by the binary inputs ExtValue3 up and ExtValue3 down. The
ExtValue 3 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 3 is written remotely
from a terminal using the appropriate command ExtValue #n.
12.2.11.20 Setpoint: ExtValue4LoLim
-32000 .. ExtValue4HiLim [X]
This setpoint adjusts the low limit of the value of ExtValue 4 if the value is
lowered/raised by the binary inputs ExtValue4 up and ExtValue4 down. The
ExtValue 4 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 4 is written remotely
from a terminal using the appropriate command ExtValue #n.
12.2.11.21 Setpoint: ExtValue1HiLim
To Next Page
Loading...
