ComAp InteliMains NT IM-NT-BB - Page 270

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
270
Range [units]
1 .. 10000 [X/s]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 3 is beeing
changed while the input ExtValue3 up or ExtValue3 down is active.
11.2.12.28 Setpoint: ExtValue4 rate
Group
Force value
Range [units]
1 .. 10000 [X/s]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 4 is beeing
changed while the input ExtValue4 up or ExtValue4 down is active.
11.2.12.29 Setpoint: ExtValue1deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
standard v3.1.0
Force value
possible
YES
Description
This setpoint adjusts the reset (initial) value of the ExtValue 1. This initial
value is applied either when the controller is powered-on or when the
ExtValue 1 is reset by the binary input ExtValue1reset.
11.2.12.30 Setpoint: ExtValue2deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
standard v3.1.0
Force value
YES