ComAp InteliNano NT Plus

InteliNano-NT Plus, SW version 2.0.1.x, ©ComAp – July 2015
78
Events 12.1
Every event listed in table below is saved in history with running hours stamp see Figure 12.3.
Figure 12.3
EVENT – POWER ON
Possible Events
Mains Return
Mains has returned. All mains parameters are within the preset range.
Mains Fail
Mains failure detection depends on Auto mains failure setpoints.
Manual Start
Engine was manually started by pressing button Start in Manual mode.
Remote Start
Engine was remotely started via input terminal’s function I02 Remote Start/Stop or
I03 Remote Start And Load. The controller is in Auto mode.
AMF Start
Engine was automatically started because of mains failure. The controller is in Auto
mode.
Manual Stop
Engine was manually stopped by pressing button Stop in Manual mode.
Remote Stop
Engine was remotely stopped via input terminal’s function I02 Remote Start/Stop or
I03 Remote Start And Load. The controller is in Auto mode.