ComAp InteliNano NT Plus Reference Guide

InteliNano-NT Plus, SW version 2.0.1.x, ©ComAp – July 2015
3
1 Document information
INTELINANO
NT
® PLUS - REFERENCE GUIDE
WRITTEN BY: ALES PETRIK, DANIEL SVANDA
©2015 COMAP LTD.
KUNDRATKA 17, PRAHA 8, CZECH REPUBLIC
PHONE: +420246012111, FAX: +420266316647
WEB: HTTP://WWW.COMAP.CZ, E-MAIL: INFO@COMAP.CZ
DOCUMENT HISTORY
REVISION NUMBER
RELATED SW. VERSION
DATE
1.4
11.3.2013
1.5
29.9.2013
1.6
1.9.2014
2.0.1.x
24.7.2015
Clarification of notation 1.1
NOTE:
These boxes contain helpful tips, reminders, and other notes.
CAUTION!
These boxes call special attention to procedures or adjustments, which if done incorrectly can cause
damage or equipment failure.
WARNING!
These boxes call special attention to important procedures or adjustments, which if done incorrectly
could result in personal injury or death.
Conformity Declaration 1.2
The following described machine complies with the appropriate basic safety and
health requirement of the EC Low Voltage Directive No: 73/23 / EEC and EC
Electromagnetic Compatibility Directive 89/336 / EEC based on its design and type,
as brought into circulation by us.
Important 1.3
SAVE THESE INSTRUCTION - This manual contains important instructions for the
InteliNano
NT
controllers’ family that shall be followed during installation and maintenance of the
InteliNano
NT
genset controllers.
This manual is intended for use by gen-set control panel builders and parties concerned with
installation, operation, and maintenance of the gen-set.
This manual describes the InteliNano
NT
Plus software, which is designed for single set, stand-by and
island applications.

ComAp InteliNano NT Plus Specifications

General

Brand	ComAp
Model	InteliNano NT Plus
Category	Controller
Language	English