ComAp InteliNano NT Plus Reference Guide

InteliNano-NT Plus, SW version 2.0.1.x, ©ComAp – July 2015
4
NOTE:
ComAp believes that all information provided herein is correct and reliable and reserves the right to
update at any time. ComAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
NOTE:
SW and HW must be compatible otherwise some functions will be disabled.
NOTE:
Because of large variety of the InteliNano
NT
parameters settings, it is not possible to describe all
combinations. Some of the InteliNano
NT
’s functions are subject of changes depend on SW version.
The data in this manual only describes the product and is not intended as a warranty of performance
or characteristics.
CAUTION!
Dangerous voltage
In no case touch the terminals for voltage measurement!
Always connect grounding terminals!
CAUTION!
All parameters are preset to initial values. But the set points in the “Basic settings” settings group
!!must!! be adjusted before the first startup of the gen-set.
!!! INCORRECT ADJUSTMENT OF BASIC PARAMETERS
CAN RESULT IN DAMAGE TO THE GEN-SET !!!
The following instructions are for qualified personnel only. To avoid personal injury do not perform any
action not specified in this User guide!!!
WARNING!
Every time the following InteliNano
NT
controller terminals are disconnected:
▪ Mains voltage measuring and / or
▪ Binary output for MCB control and / or
▪ MCB Feedback
Disconnect power supply from the InteliNano
NT
controller and/ or disconnect the binary outputs
Starter and Fuel to avoid unexpected automatic start of gen-set and GCB closing!
WARNING!
Remote control
The InteliNano
NT
controller can be controlled remotely. When working on the gen-set, ensure that
remote start is disabled.
This is done by:
Disconnect input REM START/STOP
or
Disconnect output Starter and outputs GCB Close/Open and MCB Close/Open

ComAp InteliNano NT Plus Specifications

General

Brand	ComAp
Model	InteliNano NT Plus
Category	Controller
Language	English