Condair Mk5 - Page 47

47
– Inlet valve correction
Setinletvalvecorrection(cycleratio)in%ofstandardsettingvaluetobalance
outwaterpressurevariations.
Note:ThismenupointisavailableonlywithMk5Processunits.
– Modbus address
Actual modbus address of the unit.
Note:Themodbusaddressisneededonlyforunitswithbuilt-intelemonitoring
interfaceorbuilt-inRS232/RS485serialinterface.Detailedinformationabout
the telemonitoring interface and the serial interface can be found in the separate
manualsthataresuppliedwiththeseoptions.
– Analog signal
Range of the active analog signal in V or mA, respectively.
Note:Therangeoftheanalogsignalmaybeadjustedusingtherotaryswitch
“S3” on the control board. Please observe the information given in chap-
ter 6.1.
– Software version
Currentsoftwareversionforthesteamhumidier.
– Unit type
valueleft: Max.steamcapacityinkg/h
valueright: HeatingvoltageinVAC
Modbus address
01
analog signal
0 - 5V (poti)
software version
V 1.00
inlet valve cor.
100
machine type
20kg/400V