ConectaIP IPefono WM User Manual

8
2.4 Requirements
To configure an IPefono you need:

A PC with any operating system that has a web
local network by Ethernet or Wi
 An IPefono.

Optionally a switch, depending on the scenario chosen. This must be Power over
Ethernet if the IPefono PoE has no local power supply.

One or two Ethernet cables, depending on
with RJ45 connectors.
Ethernet
SCENARIO 1
SCENARIO 2
Manual de Configuraci
To configure an IPefono you need:
A PC with any operating system that has a web
browser, with a connection to a
local network by Ethernet or Wi
-Fi.
Optionally a switch, depending on the scenario chosen. This must be Power over
Ethernet if the IPefono PoE has no local power supply.
One or two Ethernet cables, depending on
the scenario chosen (see
with RJ45 connectors.
FIGURE 5. CONFIGURATION SCENARIOS
Switch
IPefono
IP address: 192.168.22.41
Mask: 255.255.255.0
PC
Example of configuration
IP address: 192.168.0.2
Mask: 255.255.255.0
Ethernet
Ethernet
IPefono
IP address: 192.168.22.41
Mask: 255.255.255.0
PC
Example of configuration
IP address: 192.168.0.2
Mask: 255.255.255.0
Ethernet
2 – Instalación
Manual de Configuraci
ón. IPefono. V2.8
browser, with a connection to a
Optionally a switch, depending on the scenario chosen. This must be Power over
the scenario chosen (see
Figure 5)
IP address: 192.168.22.41
Mask: 255.255.255.0
IP address: 192.168.22.41
Mask: 255.255.255.0

ConectaIP IPefono WM Specifications

General

Brand	ConectaIP
Model	IPefono WM
Category	Intercom System
Language	English