ConectaIP IPefono WM User Manual

30
5.5.1 Audio sensor
The audio sensor is configured with the “
IO.audiosensor
Audio sensitivity threshold
Time threshold in milliseconds
Call to the destination when it is ON
Play a message when it is ON
Activate this output when it is ON
Below there is an example of how to co
Audio sensitivity threshold
Time threshold in milliseconds
Call to the destination when it is ON
Play a message when it is ON
Activate this output when it is ON
Configuration Guide
The audio sensor is configured with the “
audiosensor” settings (see Figure
29
off ↓
Minimum level for the audio sensor to be
activated
Time threshold in milliseconds
0
How long the above level has to last, ‘0’
if
it should be activated immediately.
Call to the destination when it is ON
○ Yes ●No
When the audio sensor is activated, the
destination configured in SIP destination
is called (VoIP/SIP settings)
Play a message when it is ON
_________
When the audio
sensor is activated it
plays file_name.wav
Activate this output when it is ON
none ↓
When the audio sensor is activated, the
selected output is activated
FIGURE 32. AUDIO SENSOR SETTINGS
Below there is an example of how to co
nfigure the audio sensor
FIGURE 33. AUDIO SENSOR EXAMPLE
low
Time threshold in milliseconds
500
Call to the destination when it is ON
Yes
Play a message when it is ON
Alerta.wav
Activate this output when it is ON
OUT1
5 – Configuration
Configuration Guide
. IPefono. V2.8
29
).
Minimum level for the audio sensor to be
How long the above level has to last, ‘0’
it should be activated immediately.
When the audio sensor is activated, the
destination configured in SIP destination
is called (VoIP/SIP settings)
sensor is activated it
When the audio sensor is activated, the
selected output is activated

ConectaIP IPefono WM Specifications

General

Brand	ConectaIP
Model	IPefono WM
Category	Intercom System
Language	English