ConectaIP IPefono WM User Manual

Manual de Configuración. IP
efono
2.5 Startup
The IPefono leaves the factory with a pre
(mask 255.255.255.0),
so that it can be connected to the IP network
different ways:

With the PC and IPefono connected to the local

With the PC and IPefono directly connected (via the Ethernet connection).
When the connection has been established according to one of the above scenarios
5
) enter the device’s IP address in the address bar of your browser, if it has not been changed:
F
IGURE
The PC needs to have access to the device’s IP network.
where necessary.
IP
address of
the IPefono
efono
. V2.8
The IPefono leaves the factory with a pre
-set IP address, either
192.168.22.41 or
so that it can be connected to the IP network
.
It can be configured
With the PC and IPefono connected to the local
network (via a switch).
With the PC and IPefono directly connected (via the Ethernet connection).
When the connection has been established according to one of the above scenarios
) enter the device’s IP address in the address bar of your browser, if it has not been changed:
IGURE
6. ACCESSING SETUP WIZARD WITH THE WEB BROWSER
The PC needs to have access to the device’s IP network.
Change the PC’s IP address
where necessary.
address of
2 – Instalación
9
192.168.22.41 or
192.168.1.61
It can be configured
in two
network (via a switch).
With the PC and IPefono directly connected (via the Ethernet connection).
When the connection has been established according to one of the above scenarios
(see Figure
) enter the device’s IP address in the address bar of your browser, if it has not been changed:
Change the PC’s IP address

ConectaIP IPefono WM Specifications

General

Brand	ConectaIP
Model	IPefono WM
Category	Intercom System
Language	English