ConectaIP IPefono WM - Page 55

Configuration Guide. IPefono.
The IPefono will go into emergency mode under any of the following conditions:

The configured input signal is activated (in the example

The emergency code is entered on the

The “EmergencyStart” HTTP command is used
(
http://192.168.22.41/EmergencyStart
And it will exit that mode under any of the following conditions:

The configured input signal is deactivated, if this is the cause of the

The end of emergency code is entered on the keyboard or a remote terminal
(*700).

The “EmergencyStop” HTTP command is used
(
http://192.168.22.41/EmergencyStop

The maximum time that the IPefono can remain in this mode
.
V2.8
The IPefono will go into emergency mode under any of the following conditions:
The configured input signal is activated (in the example
IN1).
The emergency code is entered on the
keyboard or a remote terminal (
The “EmergencyStart” HTTP command is used
http://192.168.22.41/EmergencyStart
).
And it will exit that mode under any of the following conditions:
The configured input signal is deactivated, if this is the cause of the
The end of emergency code is entered on the keyboard or a remote terminal
The “EmergencyStop” HTTP command is used
http://192.168.22.41/EmergencyStop
).
The maximum time that the IPefono can remain in this mode
has passed
5 – Configuration
49
The IPefono will go into emergency mode under any of the following conditions:
keyboard or a remote terminal (
*701).
The configured input signal is deactivated, if this is the cause of the
emergency.
The end of emergency code is entered on the keyboard or a remote terminal
has passed
(360).