19
CONVAID USER’S GUIDE
WARNING: Check proper seat module docking before placing user in chair.
Check docking by lifting front seat pan up and down to ensure seating module
does not disengage from mobility base.
WARNING: Before placing user in the chair, make sure wheel locks are
engaged.
Removing Seating Module from Mobility Base
WARNING: Always remove the user from the chair prior to removal of the
seating module from the mobility base. Removal of the seating module is only
intended for facilitating lifting and transportation of the chair. The user should
never be placed in the seating module if it is not properly attached to the
mobility base. The mobility base should never be used without the seating
module assembly properly installed.
WARNING: The seating module shall NEVER be used as a car seat.
1. Engage wheel locks.
2. Remove user from the chair.
3. Adjust the seat back to upright position.
4. Adjust tilt to neutral position so that the seat pan is parallel
to the oor.
5. Hold seat base lock bar and push safety lock release lever
6. Lift seat module safety latch lock. Fig. 20
7. Once the seating module safety latch lock is released, push
on the upper back to release seating module from docking
tubes on the mobility base.
8. Lift seating module from the mobility base.
Fig. 20
To Next Page
Loading...
