Crestron CP4-R User Manual

Product Manual – DOC. 8432A Crestron Pyng OS 2 for CP4-R • 243
After the updated device driver files have been imported into the CP4-R, apply the
updated driver to its associated third party device as follows:
• For Crestron Connected devices, no additional steps are required. Crestron
Connected devices are internal to Crestron Pyng and do not use device drivers.
• For IR devices, add the device(s) to the system after the updated driver file is
uploaded. Existing IR devices that were added using an older version of the driver
must be deleted and added back to the system.
• For Serial and TCP/IP devices (or any other DLL-based devices), delete all devices
that were added using the older firmware. Wait 60 seconds without making any
other changes to the system configuration, and then reboot the CP4-R. After the
CP4-R has rebooted, add the device(s) back to the system.
To confirm that the device was added with the updated device driver file, tap the gear
button next to the device name. The driver version is shown next to
Version in the
About section of the device settings dialog box.
Cable1 Settings Dialog Box

Crestron CP4-R Specifications

General

Brand	Crestron
Model	CP4-R
Category	Controller
Language	English