Crestron CP4-R - Appendix H: Connect to a 2 N Door Station

244 • Crestron Pyng OS 2 for CP4-R Product Manual – DOC. 8432A
Appendix H: Connect to a 2N Door Station
A 2N door station may be integrated with the Crestron Pyng system and controlled from
a supported Crestron touch screen (TSW-560, TSW-760, TSW-1060, or TSW-560P).
NOTE: The minimum TSW-x60 firmware version required to connect to a 2N door
station is 2.003.0036. The minimum 2N door station firmware version required is 2.25.0.
For more information on configuring the touch screen for 2N door station support, refer
to the TSW-560/TSW-760/TSW-1060 Supplemental Guide (Doc. 7927) at
www.crestron.com/manuals
.
Crestron Pyng supports a connection to the following 2N door station models:
• 2N IP Audio Kit
• 2N IP Audio Kit Lite
• 2N IP Base
• 2N IP Force
• 2N IP Safety
• 2N IP Solo
• 2N IP Uni
• 2N IP Vario
• 2N IP Verso
• 2N IP Video Kit
Use the procedures in this appendix to integrate a 2N door station with the Crestron
Pyng system.
NOTE: The following procedures assume that the 2N door station has been installed
completely and is discoverable on the network. For more information, refer to the 2N
device documentation.