Cupra BORN 2024 - Cornering Light Function; Daytime Running Lights; Motorway Light

Lights
119
Vehicle lighting
When the lights are on, the control lamp lights
up in green.
The automatic dipped beam is only an auxili-
ary function and cannot always identify all sit-
uations that may arise during driving with sui-
cient precision.
If the vehicle has the appropriate equipment,
the vehicle settings menu of the infotainment
system can be used to set the moment that
the dipped beam automatically switches on
›››page33.
Cornering light function
The cornering light is an additional function
to the dipped beam to improve lighting of the
side of the road when cornering at low speeds.
When the dipped beam is on, a static corner-
ing light comes on when driving at speeds be-
low about 40km/h (25mph) or on very tight
bends.
●
If the steering wheel is turned or the turn sig-
nal is switched on, the corresponding fog light
comes on progressively. Once the turn has
been made, the cornering light progressively
turns o.
●
When engaging reverse gear, both fog lights
turn on at the same time.
Daytime running lights
Daytime running lights can increase the ve-
hicle’s visibility when driving in daylight and
they turn on automatically when the ignition
is switched on (if brightness is detected).
Motorway light
The motorway light is available on vehicles t-
ted with LED High lights.
●
Activation: when going above 110km/h
(68mph) for more than 10 seconds, the dip-
ped beam raises slightly to increase the driver's
visibility distance.
●
Deactivation: when reducing the speed of
the vehicle below 100km/h (62mph), the dip-
ped beam immediately returns to its normal
position.
Warning buzzers to warn that the lights have
not been switched o
If the ignition is not connected and the driver
door is open, an audible warning signal is heard
in the following cases: this will remind you to
turn the light o.
●
When the parking light is on ›››page120.
●
When the lamp or is on.
If the exit lighting is switched on (“Coming
Home” function), when you leave the vehicle
there will be no audio warning to warn you that
the lights are still on.
WARNING
Accidents can occur if the road is not well lit
and other users of the road cannot see the
vehicle or see it with diiculty.
●
The automatic dipped beam control ( )
only switches on the dipped beam when
there are no changes in brightness, and not,
for example when it is foggy.
WARNING
The side light or daytime running light does
not provide suicient illumination to see the
road properly or to be seen by drivers of
other vehicles.
●
Always switch on the dipped beam head-
light at night, in rainy weather or when visibil-
ity is poor.
●
Daytime headlights must never be used
when the road is poorly lit due to weather or
lighting conditions.
Note
●
The relevant legislation in each country
must be observed when using the vehicle’s
lights.
●
The dipped beam headlights will only work
with the ignition on. When the ignition is
switched o, the side light automatically
turns on.