Cupra BORN 2024 - Sensitivity Adjustment; Troubleshooting

Driver information
23
Drowsiness monitor
Sensitivity adjustment
You can manually adjust the sensitivity of the
drowsiness monitor and therefore inuence
how quickly the system reacts to your driving
behaviour.
In the infotainment system:
1. Open the Assistance systems menu.
2. Open the Drowsiness monitor.
3. Select the sensitivity in the Sensitivitysub-
menu›››page33.
Concealing messages via the multi-function
steering wheel
1.
Press the button on the multifunction
steering wheel.
Drowsiness monitor warning levels
If the system detects that the driver is tired,
it indicates this visually on the instrument clus-
ter display by means of a control or warning
lamp in combination with a supplementary text
message and an audible warning. The warning
is issued at three levels.
Drowsiness monitor warning - Level 1
The system has detected that the driver is
becoming tired. An audible signal sounds.
A white control lamp and a text message
are shown on the instrument cluster dis-
play. Consider taking a break.
Drowsiness monitor warning - Level 2
The system has detected that the driver
is becoming increasingly tired. An audi-
ble signal sounds. A red warning lamp is
shown on the instrument cluster display
together with a text message. Consider
taking a break soon.
Drowsiness monitor warning - Level 3
Serious risk identied. An audible signal
sounds. A red warning lamp is shown on
the instrument cluster display together
with a text message. Serious traic risk.
Stop driving as soon as possible and pro-
ceed urgently to the nearest place where
you can take a break.
Time-related information
The drowsiness monitor detects that the
driver has been driving for 4.5 hours with-
out a break and without any recognised
fatigue. A white control lamp and a text
message are shown on the instrument
cluster display. Consider taking a break.
Troubleshooting
Availability of the drowsiness monitor is
restricted
An audio signal sounds. A yellow control light
appears along with a text message on the in-
strument cluster screen. The availability of the
drowsiness monitor is restricted.
●
Fault or malfunction. Deactivate and reacti-
vate the vehicle drive system.
●
If the problem persists, visit a duly qualied
workshop. CUPRA recommends that you visit
an oicial dealer.
 The drowsiness monitor is not avail-
able
An audio signal sounds. A yellow control lamp
appears in combination with the yellow centre
lamp. A text message is also shown on the
instrument cluster screen and in the vehicle
status menu.
●
Fault or malfunction. Deactivate and reac-
tivate the vehicle drive system. Check the
drowsiness monitor settings in the infotain-
ment system ›››page33.
●
The system limits have been exceeded.
●
If the problem persists, visit a duly qualied
workshop. CUPRA recommends that you visit
an oicial dealer.