Cupra BORN 2024 - Connecting and Disconnecting

220
Parking and manoeuvring
●
Vehicle load modies the representation of
the guide lines. The width represented by the
lines decreases with vehicle load. Pay special
attention to the surroundings when the in-
side of the vehicle of the luggage compart-
ment are loaded.
●
In the following situations, objects or other
vehicles appear to be further away or closer
than they actually are. Pay special attention:
–
If moving from a at surface to a slope
and vice-versa.
–
If the vehicle is heavily loaded.
–
When the vehicle approaches objects
that are not on the ground surface or that
protrude from it. These objects may be
outside the camera angle when reversing.
Note
●
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
●
The reverse assist reference lines disap-
pear when the rear lid is open.
Connecting and disconnecting
Connect the reverse assist
●
Select reverse gear.
●
OR: in the infotainment system select >
Driver assist > Park assist.
Disconnect the reverse assist
●
Drive forward at a speed of at least 15 km/h
(9 mph).
Shown on the display
The system’s functions and representations
may vary depending on the equipment.
Reverse assist functions and symbols
When the reverse assist is connected, you can
make adjustments using the function buttons.
Some adjustments are equipment-dependent.
Exit the current display
Switch to angle parking ›››page220
Switch to cross traic
Adjust the display: brightness, contrast
and colour.
Switch to park assist ›››page202
Display/hide the park assist view
Guide lines
Green horizontal lines: extension of the vehi-
cle.
Yellow lines:
vehicle path depending on the
steering angle.
Cross traic
This view helps to monitor traic behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.
Angle parking
Fig.145 Display on the infotainment
system screen: parking with the reverse
assistant.
Key to ›››Fig.145:
Find a parking space