Cupra BORN 2024 - Switching the Ignition On;Off

150
Driving
This may occur due to the following condi-
tions:
●
Very low state of charge of the high-volt-
age battery.
–
The control lamp comes on while the
vehicle is moving. From this moment on-
wards, the vehicle can be started twice
›››page151.
If traic conditions permit, move the vehicle
onto the right hand side of the road and park
it safely, or go to a charging station if possi-
ble.
●
Temperature and state of charge of the
high-voltage battery.
–
The control lamp turns on before the drive
system is switched on. Only manoeuvring is
possible (at a speed of up to 7km/h [4mph]).
CUPRA recommends that you charge the
high-voltage battery and prepare the car for
departure ›››page143.
Note
If you are planning to depart in low out-
side temperatures, CUPRA recommends
pre-heating the vehicle while it is parked
›››page142. Doing so also heats up
the high-voltage battery. This increases the
available power.
Limited power. Check the manual
The control lamp lights up yellow to warn you
that the power has decreased signicantly and
may decrease further.
A message is displayed in the Digital Cockpit
and an audible warning sounds.
The air conditioning comfort functions are re-
stricted ›››page133.
As soon as the battery power increases again,
the control lamp turns o.
Depending on the state of charge, CUPRA rec-
ommends:
●
When the state of charge is low, the high-
voltage battery must be charged.
●
With a high state of charge and very high
or low outside temperatures, the high voltage
battery heats up or cools down while driving.
After a certain amount of time, the available
power increases again.
Connecting and discon-
necting the drive system
Switching the ignition on/o
Fig.105 Starter button
Some vehicle functions are activated when the
driver approaches the vehicle with the corre-
sponding key.
Switching on the ignition
●
Press the brake pedal.
●
OR: press the ignition/start button once. The
ignition/start button is located on the right
hand side of the steering column.
Switching the ignition o
With the ignition on and the vehicle stopped,
press the ignition/start button once.