Driver information
Control lamps
Control and warning lamps
The warning and control lights can be lit indi-
vidually or in combination and serve as a warn-
ing, to indicate the presence of an anomaly or
to warn of the activation of certain functions.
Some turn on when the ignition is switched
on and have to be switched o after a certain
period of time.
Warning with priority 1:
●
The red central warning lamp lights up or
ashes, possibly accompanied by additional
audio warnings or symbols. Stop driving!
Danger! Check the faulty function. Seek spe-
cialist assistance as soon as possible.
Warning with priority 2:
●
The yellow central warning lamp lights up
or ashes, possibly accompanied by additional
audio warnings or symbols. Operating faults or
the lack of operating uids can cause damage
to the vehicle or a fault. Check the faulty func-
tion as soon as possible and, if necessary, con-
tact a specialist workshop immediately.
CUPRA recommends visiting an Oicial CUPRA
Service.
Lamps with other colours:
●
Green, blue, white and grey: Information on
other systems.
The control lamps that light up on the light
control are explained in chapter ›››page118,
Lights.
WARNING
If the warning lamps and messages are ig-
nored, faults may occur in the vehicle, it may
stall in traic, or accidents and serious inju-
ries may occur.
●
Never ignore warning lamps or text mes-
sages.
●
Stop the vehicle as soon as possible in a
safe place.
Note
If there are several warnings, the corre-
sponding symbols will light up for a few sec-
onds and remain lit until the cause is elimina-
ted.
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. If the fault
continues, consult a specialised workshop.
CUPRA recommends visiting an Oicial CU-
PRA Service.
Sym-
bol
Meaning
Stop driving!
Central warning lamp ›››page20
Fasten your seat belt
›››page41
Deep discharge of the high-voltage
battery ›››page80
Electronic parking brake on
›››page198
Stop driving!
Fault in the brake system
›››page162
Stop driving
Brake uid level low ›››page307
Stop driving!
The electromechanical brake servo
is not working ›››page164
Take control of the vehicle and be
ready to brake! ›››page174
Stop driving
Fault in the motor coolant uid sys-
tem ›››page306