For the sake of the environment
Do not leave the exterior mirror heating on
for longer than necessary. Otherwise it cau-
ses unnecessary energy consumption.
Note
If the electrical adjustment should fail to op-
erate, both of the mirrors can be adjusted
by hand by lightly pressing the edge of the
mirror glass.
Sun protection
Sun blind
Fig.100 Sun visor
Options for adjusting driver and front pas-
senger sun visors
●
Lower the sun visor towards the windscreen.
●
The sun visor can be pulled out of its mount-
ing and turned towards the door ›››Fig.100
1
.
●
Swing the sun visor towards the door, longi-
tudinally backwards.
There is a vanity mirror on the sun visor, with
a cover. When the cover is opened
2
a light
comes on.
The lamp goes out when the vanity mirror
cover is closed or the sun visor is pushed back
up.
WARNING
Folded sun blinds can reduce visibility.
●
Always store sun blinds and visors in their
housing when not in use.
Note
The light above the sun visor automatically
switches o after a few minutes in certain
conditions. This prevents the battery from
discharging.
Glass roof sun blind
Fig.101 On the interior roof lining:
function button to operate the sun blind.
The electric sun blind operates while the igni-
tion is switched on and can be opened and
closed using the function button on the inte-
rior roof trim.
Opening and closing the sunshade blind
●
Automatic function: swipe your nger for-
ward (open) or back (close) over the function
button ›››Fig.101. Pressing the function but-
ton stops the automatic function.
●
Manual function: swipe your nger across
the function button forwards (open) or back-
wards (close) and hold until the blind reaches
the desired position.
To Next Page
Loading...
