Cupra BORN 2024 - Vehicle Power Sockets

Practical equipment
229
Power sockets
1
/
2
3
NOTICE
●
To avoid damaging the electrical system,
never connect electrical devices that supply
power, such as solar panels or battery charg-
ers, to 12-volt sockets to charge the 12-volt
battery.
●
Only use electrical devices that comply
with the applicable electromagnetic com-
patibility directives.
●
To prevent voltage uctuations from caus-
ing damage, switch o electrical devices be-
fore switching the ignition on and o and be-
fore switching on the drive system.
●
Never connect electrical devices that con-
sume more than the specied power to a 12
volt socket. Exceeding the maximum power
consumption could damage the vehicle's
electrical system.
●
Observe the instruction manuals of electri-
cal devices!
Note
●
The 12-volt battery is discharged when
electrical devices are switched on and the ig-
nition and drive system are also switched on.
●
Uninsulated devices can interfere with the
radio, infotainment system and the vehicle’s
electronic system.
Vehicle power sockets
Fig.152 Vehicle 12-volt socket.
›››Fig.152
12-volt sockets on the right-hand side
of the luggage compartment.
12-volt sockets at the rear of the console,
between the front seats.
Make sure that the maximum power of the
sockets is not exceeded. The power consump-
tion of the devices is shown on the type plate
of the devices.
The continuous output of all of the vehicle’s
12-volt sockets is 120 watts in total.
The maximum power of each 12-volt socket
is 180 watts in total with the drive system
switched on.
Depending on the equipment and the coun-
try, the vehicle may also have USB ports ex-
clusively for charging or as a power socket
›››Fig.152
3
.
These USB ports are located at the rear of the
console, between the front seats.
NOTICE
If the 12-volt socket is used at full power for
longer than the specied time, the fuse may
blow.
●
Never use the 12-volt socket at full power
for more than 10 minutes.
●
If using full power, use a single 12-volt
socket.