Cupra BORN 2024 - Instrument Cluster

Driver information
15
Instrument cluster
Sym-
bol
Meaning
Service intervals display
›››page20
Instrument cluster
Introduction
After switching the drive system on with a 12-
volt battery that is heavily discharged or newly
replaced, some system settings (such as the
time, the date, the personalised comfort set-
tings and the programming) might be altered
or deleted. Check and correct these settings
once the battery is suiciently charged.
WARNING
Any distraction may lead to an accident, with
the risk of injury.
●
Do not operate the instrument cluster con-
trols when driving.
●
To reduce the risk of accident and injury,
only make adjustments to the instructions
on the instrument cluster display and to the
instructions on the Infotainment system dis-
play when the vehicle is stationary.
Digital Cockpit
Fig.1 Digital Cockpit on the dash panel.
The Digital Cockpit is a digital instrument clus-
ter with a high-resolution colour liquid crystal
display. In addition to the speedometer, by se-
lecting dierent information proles you can
display information from the driver assistant
systems, among other things. From here on
the Digital Cockpit will be referred to as the
“digital instrument cluster”.
Views in the display area
The digital instrument cluster can display the
following views ›››Fig.1:
●
Summary: Before switching on the drive sys-
tem: view with information on mileage (km),
battery state of charge and range.
●
Basic: Driving indications with information
on driver assistant systems, speed and naviga-
tion.
●
Driver assistant systems: Display of active
driver assistant systems and speed. The navi-
gation context is hidden.
●
Navigation: Representation with information
about the guided route and speed. The
graphic view of the driver assistant systems is
hidden.
Items such as pop-up windows are displayed
in the upper display area, depending on the
situation.
The amount and content of the information
displayed may vary depending on the equip-
ment.
Adjusting the views
The dierent views give you a better overview
of driving and navigation data or information
on driver assistant systems.
The button on the multifunction steering
wheel can be used to switch between the over-
view and the reduced view of the instrument
cluster.
●
To switch between views, tap the button
or press or swipe your nger over the buttons
or .
Incidents on the digital instrument cluster
Information and warnings are displayed on
the digital instrument cluster as incidents. In-
cidents are displayed at the top of the instru-
ment cluster and are hidden again after a short
time.