EasyManua.ls Logo

Cupra BORN 2024 - Drink Holder; Power Sockets

Cupra BORN 2024
370 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
228
Practical equipment
Drink holder
Fig.151 In the rear central armrest: drink
holder.
The storage compartments of the driver and
passenger doors contain a bottle holder.
Front drink holders
There are two cup holders in the centre con-
sole .
Drinks holder in the rear central armrest
Use: Lower the central armrest ›››Fig.151.
When the drink holder is no longer in use, lift
the armrest again.
WARNING
Incorrect use of the bottle holders may cause
injuries.
Never put hot drinks in the drink holders.
In the event of sudden braking or an acci-
dent while driving, hot beverages in the bot-
tle holders might spill and cause burns.
Ensure that no bottles or other objects are
dropped in the driver footwell while driving,
as they could get under the pedals and ob-
struct their working.
Never place glasses, food or other heavy
objects drink holders. These heavy objects
may be thrown across the cabin in the event
of an accident and cause serious injuries.
WARNING
Closed bottles may explode inside the vehi-
cle due to cold or heat.
Never leave closed bottles in the vehicle if
the temperature inside is very high or very
low.
NOTICE
Do not leave open cans in the drink holders
when the vehicle is in motion. If the drink is
spilled (e.g. due to sudden braking) it may
damage the vehicle and its electrical system.
Note
The inside elements of the drink holders can
be extracted for cleaning.
Power sockets
Introduction
Electrical equipment can be plugged in to the
vehicle's sockets.
The devices must be in a perfect state of re-
pair. Do not use defective devices.
The 12 volt power socket will only work with the
ignition on.
WARNING
Improper use of the sockets or electrical de-
vices could lead to a re and cause serious
injuries.
Please ensure that children are never left
unsupervised inside the vehicle. The sockets
and the devices connected to them can be
used when the ignition is switched on.
If electrical devices overheat, switch them
o immediately and disconnect them from
the power supply.

Table of Contents

Related product manuals