Cupra BORN 2024 - Page 281

Infotainment system
279
Telephone interface
1)
It only includes the wireless charge functionality.
●
Wireless Charger
1)
.
●
Mobile Signal Amplier.
Wireless charger
If your mobile device is equipped with in-
duction charging (Qi) technology, it can be
charged wirelessly.
To charge your mobile phone wirelessly:
●
Place your mobile device in the middle of
the pad with the screen facing up ›››Fig.160.
Make sure there are no objects between the
pad and the mobile phone.
The mobile phone will start charging automat-
ically. For further information about whether
your mobile device supports Qi technology,
check your phone's user manual or visit the
CUPRA website.
Mobile Signal Amplier
This reduces radiation in the vehicle and gives
you better reception.
For safety reasons, it is recommended that
you pair the system and the mobile using Blue-
tooth® and place it on the Connectivity Box
pad, for the best reception without having to
handle the mobile phone.
For connection to the vehicle’s external an-
tenna:
●
Place your mobile device in the middle of
the pad with the screen facing up ›››Fig.160.
Make sure there are no objects between the
pad and the mobile phone.
Your mobile phone will automatically be able to
use the external antenna function.
WARNING
Notications on the screen of the mobile de-
vice can distract the driver’s attention and
increase the risk of a serious accident.
●
Only place one suitable mobile device,
with Qi compatibility if applicable. To ensure
that it operates properly, place it without the
protective case and ensure that it has max-
imum dimensions (width x length) of 80 x
140mm (3.15 x 5.512 inches) on the base of
the Connectivity Box as indicated.
●
If the mobile device is not placed on the
base of the Connectivity Box, in the correct
position, or if its dimensions exceed those
specied, it may not be recognised or may
not charge correctly. Under certain circum-
stances, the infotainment system indicates
that there is a foreign object in the storage
compartment. Using a suitable mobile phone
device and correcting its position can elimi-
nate the fault.
●
If necessary, remove any objects that may
obstruct the cover’s closing function.
●
While driving, always keep the armrest
cover closed and the screen of the device
completely covered.
WARNING
●
The mobile phone may become warm due
to wireless charging. Think about this before
you pick it up, and take care when removing
it.
●
There must be no metallic or other objects
between the mobile phone and the housing,
to prevent the functionality of the Connec-
tivity Box from being aected.
NOTICE
Do not leave the key near the
Wireless
Charger area as this may cause interference.
NOTICE
A active NFC function on your mobile device
may prevent its wireless charging from work-
ing properly. CUPRA recommends that you
deactivate the NFC function on your mobile
device when charging.