Main
Enable the back gauge stop against a slope segment
When this criteria is validated, the software accepts that a part of the productknocks against
a point of the machine with a flexibility in % of the length of the sheet between the bend
and the end of the product on the side of the profile which enters in to collision.
The software arranges that the section error is located on the specified face.
Secondary
The software will choose the solution which demands the least possible number of swings.
The software will choose the solution which demands the least possible number of returns.
The software will choose the solution which demands the least possible number of
flipovers.
Limit the number of bends (already realized) situated between the backgauge and the bend
to be realized.
To Next Page
Loading...
Need help?
General
