By Pressing in the selected material is possible to set custom configuration
The Custom configuration page displays:
• Predefined Thickness: If activated is possible to set predefined thickness for the
material.
• Springback Correction If activated is possible to set corrections of the springback
effect of the material for different angles degrees.
• Thickness compensation factor: If activated is possible to set corrections of the
thickness effect of the material for different angles degrees.
This parameter allows the operator to apply a permanent correction to the Bottom Dead
Centre position.
Please note that this correction is always applied and is NOT shown in the
correction page. If you experience big differences from what you expect to get,
maybe check the value of this parameter.
This parameter allows the operator to choose on which side – Left of Right – he prefers to
have the side bar containing the Menu Button .
This parameter allows the operator to choose if he prefers to have the menu displayed at
the Bottom or at the Top of the screen when he presses the Menu Button .
To Next Page
Loading...
