This parameter allows choosing between mm, inch and none for the length unit to be used
in the VisiTouch.
When none is selected, the units used are millimetres.
This parameter allows choosing between ton, kN and tons for the force unit to be used in
the VisiTouch.
This parameter allows choosing between ton/m, kN/m and tons/ft for the force/length
unit to be used in the VisiTouch.
This parameter allows choosing between kg/mm2, N/mm2 and psi (*1000) for the sigma
unit to be used in the VisiTouch.
This function will display the axes positions on the Bend Numerical Page.
• When set to no, the position of axes Y1, X and R is displayed during the beam’s
movements.
• When set to yes1, the positions of the axes (Y1, Y2, X and R) are displayed during
their respective movements.
• When set to yes2, the positions of the axes (Y1, Y2, X and R) are constantly
displayed under their respective set-point values.
This parameter, when activated, lets the operator see the state of the part before and after
the bend in the Bend Sequencing page.
To Next Page
Loading...
Need help?
General
