When activated, this function clears the index and the machine will search for them, as
it does when turning the power on, allowing the operator to re-index its machine without
turning it off.
When this parameter is set to yes, it is possible to browse the USB key from the USB
transfer screen (see USB Transfer).
A USB key must be inserted.
Preferably use a specific USB key for transferring parts and VisiTouch Data
instead to use a generic memory stick full of data programs that are not relevant
for the numerical control.
When this parameter is set to yes, this small button is displayed on the Status page. By
activating/deactivating it, one can start and stop the recording of beam traces.
When activated, this function will open the beam trace screen automatically at the end of
the recording.
This parameter allows defining the default value displayed in the Extra Bending
Parameters when activating the back-gauge retraction function.
In TouchProfile Mode, when a retraction is necessary, the numerical control will
automatically calculate and activate the function. The calculated value can naturally
be manually modified.
Allows the user to set the time and date on the VisiTouch.
To Next Page
Loading...
