All program corrections are made in the Bend Numerical Page. According to his preferences,
the operator can choose to execute all the steps of the program one after the other, making
corrections along the way or he can choose to apply all the corrections necessary to the
same step before moving to the next one using the Semi-Automatic mode.
Corrections can be made to:
• The angle (Y1 + Y2, see Angle Correction (Y axis) and/or crowning if available, see
Crowning),
• The back-gauge position (X and R, if available), see Back gauge (X & R axes)
Correction.
The semi-automatic mode allows repeating the same sequence indefinitely. It is used
when the operator wants to apply corrections to his part one bend after another. He can
thus execute the same step until he gets the desired result, before moving to the next
one by means of the button.
The semi-automatic mode is activated (and deactivated) by touching for more than one
second on the button.
To Next Page
Loading...
