5. Corrections to the crowning value can be made by touching this icon .
6. The numerical control automatically calculates the Pinch Point height. If it needs
correction, it can be done by touching this icon .
The greyed value next to the Pinch Point correction icon is the value calculated by
the numerical control, and thus the value onto which the correction will be applied.
7. Touching the values next to any axes allows entering a correction.
The axes corrections can be positive or negative and will be added to the axes
positions.
The back-gauge positions corrections can also directly be made on the Bend
Numerical Page.
To Next Page
Loading...
Need help?
General
