D-Link DXS-1210 Series - Command Line Interface; CLI Command:?; CLI Command: config ipif

4 Configuration D-Link DXS-1210 Series User Manual
96
NOTE: Cable length detection is available on
Gigabit ports only.
NOTE: Please be sure that the
Power Saving
feature is disabled before enabling the Cable
Diagnostics function.
Monitoring > Statistics > Port
This page allows you to display the packet statistics of ports.
Figure 4.163 – Monitoring > Statistics > Port
From Port / To Port: Select the range of ports to be configured.
Click the Find button to locate a specific entry based on the information entered.
Click the Refresh button to refresh the display table.
After clicking the Show Detail button, the following page will appear.