D-Link DXS-1210 Series User Manual

5 Command Line Interface D-Link DXS-1210 Series User Manual
104
<ipv6_addr> - The IPv6 address of the host.
<value 1-60000> - Specify the ping packet size.
<time_out 1-100> -
Specify the time out value. The range is
between 1 and 100 seconds.
repeat <integer 0-255> - Specify the repeat time.
Restrictions Only Administrator or operator-
level users can issue this
command
Example usage:
To ping the IP address 10.90.90.98:
DXS-1210-12TC> ping 10.90.90.98
Reply Not Received From : 10.90.90.98, Timeout : 1 secs
Reply Not Received From : 10.90.90.98, Timeout : 1 secs
Reply Not Received From : 10.90.90.98, Timeout : 1 secs
--- 10.90.90.98 Ping Statistics ---
3 Packets Transmitted, 0 Packets Received, 100% Packets Loss
DXS-1210-12TC>
reboot
Purpose To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax
reboot
Description
The reboot command
reboots the system. All network
connections are terminated and the boot code executes.
Parameters None.
Restrictions None.
Example usage:
To restart the Switch:
DXS-1210-12TC> reboot
Are you sure you want to proceed with the system reboot?(y/n)y
Do you want to save the settings ?(y/n)y
DXS-1210-12TC>
reset config
Purpose To reset the Switch to the factory default settings.
Syntax
reset config
Description All configurations will be reset to the default settings.
Parameters
None.

D-Link DXS-1210 Series Specifications

General

Product Series	DXS-1210
Power Supply	Internal
Jumbo Frame Support	9KB
Number of Ports	12
Layer	L2+
Form Factor	Rack-mountable
Uplink Ports	10G SFP+
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C