D-Link DXS-1210 Series - Hardware Installation; Step 3 - Plugging in the AC Power Cord; Power Failure Precautions

2 Hardware Installation D-Link DXS-1210 Series User Manual
7
7
Figure 2.3 – Mount the Switch in the rack or chassis
Step 3 – Plugging in the AC Power Cord
The Switch can now be connected to the AC power. Connect the AC power cord to the rear of the switch and
to an electrical outlet (preferably one that is grounded and surge protected).
Figure 2.4 –Plugging the switch into an outlet
Power Failure
As a precaution, the switch should be unplugged in case of power failure. When power is resumed, plug the
switch back in.