5 Command Line Interface D-Link DXS-1210 Series User Manual
106
Example usage:
To display IPv6 interface settings:
DXS-1210-12TC> show ipv6 interface 1 brief
vlan1 is up, IPv6 is enabled
Link-local address:
fe80::ee22:80ff:fe77:2016, Link status is up
Total Entries: 1
DXS-1210-12TC>
show switch
Purpose To display information about the Switch.
Syntax
show switch
Description
The show switch command displays the status of the switch.
Parameters None.
Restrictions None.
Example usage:
To display the switch information:
DXS-1210-12TC> show switch
System Name :Switch
System Location :
System Contact :
System Time :27/04/2011 18:25:37
System hardware version :A1
System firmware version :V1.00.021
System boot version :V1.00.003
System serial number :S34F1E8000036
MAC Address :ec-22-80-77-20-16
DXS-1210-12TC>
config account username
Purpose To configure the configuration of user account on the Switch.
Syntax
config account username <string <32> privilege <short <1-
15>> { nopassword | password <string <32>}
Description
The config account username command sets the administrator