D-Link DXS-1210 Series User Manual

5 Command Line Interface D-Link DXS-1210 Series User Manual
1
1
0
0
5
5
Restrictions Only Administrator can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DXS-1210-12TC> reset config
This command will clear all of system configuration as factory. System will
reboot after clearing. Do you want to continue? (y/n)y
DXS-1210-12TC>
show ipif
Purpose To display the configuration of an IP interface on the Switch.
Syntax
show ipif [<short <1-4094>>]
Description
The show ipif command displays the current IP address of the
switch.
Parameters
[<short <1-4094>>] - Specify the interface to be displayed.
Restrictions None.
Example usage:
To display IP interface settings:
DXS-1210-12TC> show ipif
IP Setting Mode :manual
Interface Name :vlan1
Interface Vlan Name :default
IP Address :10.90.90.90
Subnet Mask :255.0.0.0
Total Entries: 1
DXS-1210-12TC>
show ipv6
Purpose To display the configuration of an IPv6 interface on the Switch.
Syntax
show ipv6 interface [<short <1-4094>>] [brief]
Description
The show ipv6 command displays the current IPv6 address of
the switch.
Parameters
[<short <1-4094>>] - Specify the interface to be displayed.
[brief] – Specify the brief of interface to be showed.
Restrictions None.

D-Link DXS-1210 Series Specifications

General

Product Series	DXS-1210
Power Supply	Internal
Jumbo Frame Support	9KB
Number of Ports	12
Layer	L2+
Form Factor	Rack-mountable
Uplink Ports	10G SFP+
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C