D-Link DXS-1210 Series User Manual

5 Command Line Interface D-Link DXS-1210 Series User Manual
102
save {startup-config | config-1 |
config-2}
Save configuration.
boot image [image-1 | image-2]
Select the boot up image.
debug info
Displays Debug Table.
debug show tech-support
Displays technical support information.
Each command is listed in detail, as follows:
?
Purpose To display a list of commands.
Syntax
?
Description
The ? command displays a list of commands of the switch.
Parameters None.
Restrictions None.
Example usage:
To display a list of commands of the switch:
DXS-1210-12TC> ?
USEREXEC commands :
config ipif <short <1-4094>> { ipaddress <ip_addr> <ip_mask> | dhcp | bootp }
config ipif <short <1-4094>> {ipv6address <ip6_addr> <short <1-
128> |
dhcpv6_client <enable | disable>}
debug info
logout
ping [<ipv4_addr> | <ipv6_addr>] [size <value <1-
60000>>] [timeout <time_out
<1-100>>] [repeat <time>]
reboot
reset config
save
show ipif [INTERFACE-ID]
show switch
DXS-1210-12TC>
config ipif
Purpose To configure the System IP interface.
Syntax
config ipif <short <1-4094>> { ipaddress <ip_addr>
<ip_mask> | dhcp }
config ipif <short <1-4094>> {ipv6address <ip6_addr> <short
<1-128> | dhcpv6_client <enable | disable>}
Description
The config ipif system
command configures the System IP
interface on the Switch.
Parameters
short <1-4094> − Specifies the name of ipif setting.
ipaddress <ip-addr> <ip_mask> − The IP address and subnet
mask to be created. Users need to specify the address and mask

D-Link DXS-1210 Series Specifications

General

Product Series	DXS-1210
Power Supply	Internal
Jumbo Frame Support	9KB
Number of Ports	12
Layer	L2+
Form Factor	Rack-mountable
Uplink Ports	10G SFP+
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C