D-Link DXS-1210 Series - Configuration; Security > DHCP Server Screening > DHCP Server Screening Port Settings; Security > Safeguard Engine; Security > Trusted Host

4 Configuration D-Link DXS-1210 Series User Manual
8
8
5
5
Figure 4.142 – ACL > ACL Configuration Wizard – Create IPv6 ACL-PCP
Source: Select the source information. The values are Any, Host and IP.
Destination: Select the destination information. The values are Any, Host and IP.
DSCP (0-63): Enter the DSCP value. And the range is between 0 and 63.
Flow Label (0-1048575): Enter the flow label value. This value must be between 0 and 1048575.
Time Range: Enter the time range.
Action: Select the action for the rule. The values are Permit and Deny.
After selecting the SCTP option as the Protocol Type then click the associated tabs with IPv6 Address,
IPv6 DSCP and Flow Label, the following page will appear:
Figure 4.143 – ACL > ACL Configuration Wizard – Create IPv6 ACL-SCTP
Source: Select the source information. The values are Any, Host and IP.
Destination: Select the destination information. The values are Any, Host and IP.