xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
118
DES-3528:admin# config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
show 802.1 default_priority
Purpose
Used to display the current configured 802.1p priority value that will be assigned to an
incoming, untagged packet before being forwarded to its destination.
Syntax show 802.1p default_priority {<portlist>}
Description
This command is used to display the current configured 802.1p priority value that will be
assigned to an incoming, untagged packet before being forwarded to its destination.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
Restrictions
None.
Example usage:
To display the current 802.1p default priority configuration on the Switch:
DES-3528:admin# show 802.1p default_priority
Command: show 802.1p default_priority
Port Priority Effective Priority
---- ----------- ------------------
1 0 0
2 0 0
3 0 0
4 0 0
5 0 0
6 0 0
7 0 0
8 0 0
9 0 0
10 0 0
11 0 0
12 0 0
13 0 0
14 0 0
15 0 0
16 0 0
17 0 0
18 0 0
19 0 0
20 0 0
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
enable hol_prevention
Purpose
Used to enable the HOL prevention state.
Syntax enable hol_prevention
Description
This command is used to enable the HOL prevention function on the Switch.
Parameters
None.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To enable HOL prevention:
To Next Page
Loading...
